Getting out the copper wire and wiring the bottom hull together. Starting with the two bottom pieces and keeping the tape sides to the inside, wire them togther, loosely from the front third of the hull to the aft third. Only tightly wire the bow and stern. When this is done, open the pieces up like a book and insert the two bulkheads and wire them up to hold the hull open. Then the hull sides, one at a time can be wired, also the fore and aft temporary forms can be wired in to hold shape. The two center bulkheads are permanent, the two end forms will NOT be glued, only temporarily wired. In a very short time, your task will look like this....a boat! That was fast!
No comments:
Post a Comment